SynthForge Circuit Designer
Loading...
SynthForgeANALOG CIRCUIT LAB
LIVE SIMULATION 48.0 kHz

CIRCUIT WORKSPACE

3340 VCO / Sawtooth Core

SIGNAL LOCKED ↺Reset values

FOLLOW THE SIGNAL

Wire it in this order

Choose a step below; the matching part lights up here.

CURRENT STEP HIGHLIGHTED
Step 1 · Power the core

ASSEMBLY GUIDE

Put the circuit together

1 / 4
STEP 1 · START HERE

Power the circuit

Connect the positive rail and ground first. Every other part needs this reference before the signal can move.

CONNECTIONS
VCCGROUND
+
Power railProvides the reference voltage for the circuit.
PLACE & WIRE

Start at the power rail shown at the bottom of the schematic.

    This is a learning schematic, not a pin-accurate build sheet. Check the real IC datasheet before wiring hardware.

    Next step→
    iFollow the signal from left to right: source → shaping → output. The highlighted step shows what to wire next.

    PHYSICAL BUILD PLAN

    Assemble it on a breadboard

    Turn the learning schematic into a safe, testable low-voltage prototype.

    BREADBOARD
    !

    Power off before moving a wire. Use the exact IC datasheet and a current-limited supply; this guide is a wiring method, not a pinout.

    STEP 1 · OF 6

    Prepare the bench

    PARTS ON THE BENCH

    NODES TO LABEL

    ✓
    CHECK BEFORE POWER

    ↔
    SCHEMATIC MATCH

    Next physical step→

    BENCH WORKSHEET

    Wire the selected module

    Use the module recipe below as a second pass after the six-stage build plan.

    MODULE RECIPE
    SELECTED MODULE RECIPE

      TEST POINTS
      IF THE TEST FAILS

      iBuild one module at a time. Test the power rails first, then add one signal section and verify it before continuing.

      CIRCUIT ANATOMY

      Read the signal path

      A closer look at what each part does, in plain language.

      R·C

      01INPUTPitch CV
      →
      02CORERC timer
      →
      03OUTPUTAudio out
      COMPONENT ROLES
      BENCH CHECKLIST
        !
        REAL-WORLD NOTE

        LIVE INSTRUMENTATION

        Oscilloscope

        OUTPUT1.00 kHz
        0 ms5 ms10 ms
        +50-5
        VCO OUT / SAW
        Drag a control to reshape the signal in real time